Di-GPS Mini 3-MTK Series Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Navigatoren Di-GPS Mini 3-MTK Series herunter. di-GPS Mini 3-MTK Series Instruction manual [en] Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - Dig Spice Co., Ltd

Sports Driving Analysis Tool DigSpice Instruction Manual Ver. 1.1.1 March 2011 Dig Spice Co., Ltd.

Seite 2

9 This icon indicates battery status. LED (Red) flash ・・・・ Indicates that remaining battery is very low. Battery

Seite 3

10 ⑫ If a communication error or time out occurs or if the USB cable is pulled out when the GPS Logger is reading the log, make sure the go through

Seite 4

11 ※ GPS signals can attenuate significantly due to metals, human body, and water. Be sure to mount it where the satellite is always visible.

Seite 5

12 that it does not fall off due to vibration. Mount the device using strong double-sided adhesive tape on the case bottom. Mounting stay If t

Seite 6 - Note and Warning

13 5. Data Log 5.1 Important points before measuring(Hints on collecting accurate data) Dig Spice uses the GPS to locate your car’s position, and it

Seite 7

14 6. DRIVING ANALYSIS SOFTWARE 6.1 Screen display explanation □ Tab Graph Analysis of Log data Data Save/Load of Log data

Seite 8

15 The setting should be done in Navi Mode by connecting the GPS logger with the PC using the USB cable in the package. 6.2.1 Log time setting

Seite 9 - (Caution)

16 Once the mode setting is completed, the GPS logger setting status will appear on the “Confirm setup details, Check available log memory space” sec

Seite 10

17 Erase Finish Select OK ≪ Error Message≫ The message above means that the program could not recognize it is Dig Spice products.

Seite 11

18 Please specify the identification number on the error message and contact Dig Spice via the website. 6.3 Read driving data from the GPS logger

Seite 12

1 Table of Contents 1. Introduction ... 5 1.1 Exterior Parts ...

Seite 13

19 6.3.3 After connection is complete, with the cable connected, please change to Navi Mode. (Refer to section 1.2) LED □ Power (Green light

Seite 14

20 When loading is complete, the “Save log under a new file name” window will open, so save the file under a new name. (The initial file name will b

Seite 15 - ■ ツ ー ル バ ー

21 Log Data Graphic Display <Log Data Graphic Display> The screen shows a straight line, < The screen shows a straight line> Zoom ran

Seite 16

22 Zooming in on the START or END section It is displayed by zooming < Zooming data>

Seite 17

23 6.3.4 Error message 6.3.4.1 Connection failure with GPS logger Measures ① Make sure the GPS logger and the PC are firmly connected with

Seite 18

24 Measures 【 GPS】 Tab> “Confirm setup details, Check available log memory space” status (Refer to Section 6.2.2) 6.4 log data shift. Cancel zo om

Seite 19 - Accessory USB cable

25 Log data and circuit map Graphic display. < Display driving data and circuit map and make adjustments > Log data and circuit map ex

Seite 20

26 Choose the control line data of the run circuit and push "OK". < Choose the control line> Control line is drawn (Black Line) &l

Seite 21

27 < The manual setting control line> Click “OK” □ Rally, trial, hill climb: Specify the positions with Start setting and Finish setting. Chec

Seite 22

28 Once the measurement line is set, click OK and the detailed data by lap will be displayed in the analysis window under the 【 Data】 tab.

Seite 23

2 6.2.1 Log time setting ... 15 6.2.2 Confirm setup details, available log memory

Seite 24

29 Returns to “Control line, Start/Finish setting” window. Displays “Control line, Start/Finish setting” window. 6.8Choose to show graph/Cance

Seite 25

30 This saves the lap data list as a CSV file <Display> <OUTPUT FILE> 6.11 Save split data This saves one split data as a drivin

Seite 26

31 This saves one Lap data as driving data as CSV file. Select Lap data. <Display> <OUTPUT FILE> 7. Detailed Analysis 【 Graph】

Seite 27

32 7.1 Description of displays (Switch) 7.1.1 Tabs Graph : Analysis of driving Data : Input/output of driving data GPS : GPS logger setti

Seite 28

33 Clear graphReset playbac k timePlayback/stop (Space bar)Step next frame("F"Key)/Setp previous frame("B" Key)Playback speedSet

Seite 29

34 7.2 Sector setting when passing the same point more than once Used mainly for slalom competitions (such as gymkhana, dirt trial). If the sec

Seite 30

35 7.3 Adjustment function of set sectors Set the sectors and click the below button. Select the sector to be adjusted. Specify the locati

Seite 31

36 7.4 Display/hide course layout tool on animation window Clear c ircuit mapGenarate circuit mapLoad / Save circuit mapAdjust circuit mapShow

Seite 32

37 7.4.4 Create course layout You can create original course layout. Follow the following steps when creating a course layout. ①  Make a circui

Seite 33 - G/Radius of turn

38 ⑥ Select OK to display lap data. Select the driving data for the inner rim and outer rim of the course. ⑦ Create course layout T

Seite 34

3 7. Detailed Analysis 【 Graph】 ... 31 7.1 Description of displays (Switch) ...

Seite 35

39 ⑧ Save course layout Save the created course layout with a name. ⑨ Completed course layout When you open a saved course layout, the disc

Seite 36

40 7.5.1 Speed window 【 Zoom in】 The analysis data selected in 【 Data】 is displayed as a graph. X-axis (Horizontal): Driving distance/

Seite 37 - Show/Hide circuit map tool

41 If you set in the Middle of the ZONE, you will get more specific result. ▼ Speed Graph Base Point This Triangle shows the agreement of driving li

Seite 38

42 <Sector details> The sector details will display the best lap for the sector among the selected laps, and then display the total time for t

Seite 39

43 【 Friction circle】 Braking G Acceleration GLeft turn GRight turn G This figure shows Acceleration G on the vertical axis and Cornering G on the

Seite 40

44 ( Example) Analysis of driving data on SUZUKA Circuit( 2 vehicles) 【 G Force/ Radius of turn】 【 G/ Radius of turn Graph】 □ G Force X axi

Seite 41

45 The light Red○ and Blue○ show the G dispersion of all data for the 2 vehicles being analyzed. The dark large Red○ and Blue○ show… The

Seite 42

46 -:+:Zoom OUT of the graph (The enlarged reduction is possible by a scroll wheel ) ○i : This shows the points to note when displaying G Force a

Seite 43

47 7.5.2.2 How to read the graph A larger G Force distribution indicates that the tire performance is being fully used in the driving. (Howeve

Seite 44 - Turn Apex

48 Display for both vehicles (A vehicle= Red, B vehicle= Blue) The Red vehicle data is dispersed outside the Blue vehicle for braking and corneri

Seite 45

4 8.2 Setting minimum lap distance/minimum lap time ... 54 8.3Setting Speed/Distance indication ...

Seite 46

49 SUZUKA Circuit130R analysis If we compare the bottom speed at 130R, there is a difference of 23km/h. Should the Blue vehicle simply speed up her

Seite 47

50 This is a comparison of Cornering G. Both vehicles exceeded 1.1G, which are values close to the tire limit. Therefore, it tells that the Bl

Seite 48

51 Double click the sector information cell. Or select the sector information cell and click the below button. 7.5.4 Animation window The data re

Seite 49

52 Solid line( Red- Blue- Green- Yellow )・ When at constant speed and accelerating Dotted line ・・・・・・ ・ ・ ・ ・ ・ ・ ・ ・ ・ When decelerating Solid

Seite 50

53 8.SETUP 8.1 Setting Sector Gate Length Set the gate length when sectors are setup. (Default 15m) Specify the gate (line) by setting how ma

Seite 51

54 ※ Guideline for setting value Circuit: 15~ 20 meters Mini circuit: 10~ 15 meters Cart circuit: 8~ 10 meters Trial competition: 8~ 10 meters 8.2 Se

Seite 52

55 9. RESET GPS MODULE Please operate when the Logger does not work properly. When you need to operate the Rest GPS module, 【 GPS】 > Setup S

Seite 53

56 10. FAQ 9.1 Analysis Software Q: How much disk space do you need to install the software i n a PC? A: 200MB is needed. Be sure to use a PC w

Seite 54

57 A: The vibration may be directly affecting the GPS logger. Use rubber or other material to prevent GPS Logger from the vibration. Q: What is the

Seite 55

58 11. Hardware Specifications GeneralFrequency L1,1575.42MHZC/A Code 1.023MHZDatum WGS84Performance CharacteristicsPosition Accuracy Without a

Seite 56

5 1. Introduction Thank you very much for purchasing a DigSpice product. We are certain that this Dig Spice product will be a useful tool in your

Seite 57

59 Recommended System Environment The minimum specifications recommended for the computer using the driving analysis software are as follows. ・

Seite 58

6 Analysis may be done with lower than above specification, but Driving Animation may not function smoothly. If the animation does not function smoot

Seite 59

7 LED □ Power (Red and green Light is on while USB cable is connected, and tuned off if the cable is not connected). □ GPS (Orange light on) □

Seite 60

8 If the product is damaged or accessory is missing when you open the package please contact the store where you purchased the product. ① GPS logge

Kommentare zu diesen Handbüchern

Keine Kommentare