Di-GPS Mini 3-MTK Series Bedienerhandbuch PDF herunterladen (Seite 14)

5. Data Log

5.1 Important points before measuring(Hints on collecting accurate data)

Dig Spice uses the GPS to locate your car’s position, and it needs to

receive correct signal from the satellite to accurately measure its

position. It may take about 30 minutes to receive all of the correct data.

Therefore, you must need to turn on the GPS Logger and wait about 30

minutes before start driving in order to be ready the unit.

Beginning the drive immediately after starting to receive data may

result in errors in position information. If you start driving right after

start receiving the data, the device does not work properly due to the

positioning error.

In addition, please note that turning the power on inside a roofed area

and starting the drive before capturing satellite signals, or starting the

log without having captured satellite signals may cause an error as

well.

You do not need to wait 30 minutes if you take the data 2

or more

times at the SAME course, but you need to wait at least 5 minutes to

capture the satellite signal.

5.2 Begin data logging

The GPS logger should be in Log Mode for the sports drive.

(Caution)

Turn the power OFF after the drive.

If you do not turn off the power right after the sports driving, GPS

Logger will keep logging the data, so the unit will miss -read the signal

and will not identify the actual sports driving. (Refer to Section 6.3.3)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Keine Kommentare

Di-GPS Mini 3-MTK Series Bedienerhandbuch Seite 14